C90s in Essex

No boat building this weekend, but a bimble through beautiful Essex instead with the C90 Club.

Temporary Worktop

I fitted a piece of shuttering ply as a temporary work top so I could juggle things around and see how it all fits together before I get the real one cut.  I had a bit of a panic when I found that the cut out for the hob is too big for the 500mm unit underneath.  Then I realised that the cut out is only 50mm deep and the work top 60mm, so it doesn't matter.  Doh.

 

I have been playing around with making a bit of moulding to act as a sort of dado along the cabin sides.  Something like this but it needs to be a little deeper and I also want it vertical to the floor, not angled to the top sides.  A dark hard wood would be nice but I think my budget dictates that its going to be varnished pine.

 

 

Windy weekend

Well, I spent a very windy, wet Bank Holiday on the boat.  It was certainly lively.  There were occasions when I found it difficult to mark and measure things and once or twice I 'missed' a screw with the screwdriver when the boat gave a sudden lurch.  No damage done except my toe onto which I dropped the solid fuel stove.  Nothing to do with the wind - all my fault.

I fitted my new gas tap, but then had to remove it when I realized I had put it right where the end of one of the kitchen units goes.  I shall have to re-think this.  I need to buy some more 10mm copper pipe but I am reluctant to buy a 5m coil when I only need a few cm.  Maybe one of the DIY stores sell short lengths.

On to the kitchen units.  I've done a few of them over the years and they are pretty straight forward.  Best thing I have found is to put them all together and then play around with them until they all fit into place.  I decided to raise them up on blocks since I find 'regular height' work surfaces hard on my back and I want to be able to use the storage space under the units, behind a removable plinth.

I will be fitting a piece of ply over the units for a temporary work top.  This will give me the opportunity to juggle the hob, sink and tap and make sure they all fit right, before I have my 'special' work top cut to size.

The walls are peppered with holes where various things have been fitted over the years.  These have been filled and will be sanded next time with an orbital sander.

I continued with the lower paneling and that is now complete except for the bedroom.  Then came the saloon floor.  This was done in 12mm parquet style laminate from B&Q Being wide boards (only 4 across the boat) they were a bit of a trial to get right, but once down I think they look good.  There is a bit of a bigger gap at each side than I would have liked but it was unavoidable due to the pattern.  Not a big deal, I will just have to fit a wider skirting board.

   

The lower panels were given two coats of soft sheen 'Fresh Catch' green which I think contrasts nicely with the light floor.

I fitted a few sockets under the gunnel.  These will be hidden by a dado rail that will run along each side.  After a good tidy up and another car load of rubbish,  I just had time to plumb in my custom header tank for the heating system.